3.7Eth-Trunk以太网链路聚合配置示例
3.7.1手工模式配置
# 配置SW-A
进入系统视图后，创建链路聚合组-->配置链路聚合模式为手工模式--> 将成员接口加入聚合组
[SW-A]interface eth-trunk 1 #创建链路聚合组，接口编号为1
[SW-A-Eth-Trunk1]mode manual load-balance #配置链路聚合模式为手工模
[SW-A-Eth-Trunk1]trunkport GigabitEthernet 0/0/1 to 0/0/3 #将成员接口加入聚合组
Info: This operation may take a few seconds. Please wait for a moment...done.
[SW-A-Eth-Trunk1]
# 配置SW-B
[SW-B]interface eth-trunk 1
[SW-B-Eth-Trunk1]mode manual load-balance
[SW-B-Eth-Trunk1]trunkport GigabitEthernet 0/0/1 to 0/0/3
Info: This operation may take a few seconds. Please wait for a moment...done.
[SW-B-Eth-Trunk1]display eth-trunk 1
Eth-Trunk1's state information is:
WorkingMode: NORMAL Hash arithmetic: According to SIP-XOR-DIP
Least Active-linknumber: 1 Max Bandwidth-affected-linknumber: 8
Operate status: up Number Of Up Port In Trunk: 3
--------------------------------------------------------------------------------
PortName Status Weight
GigabitEthernet0/0/1 Up 1
GigabitEthernet0/0/2 Up 1
GigabitEthernet0/0/3 Up 1
[SW-B-Eth-Trunk1]
